P1125 OBD Trouble Code
8 results found
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | TP Sensor Circuit (Intermittent) Conditions |
| Cause | Engine running, then the PCM detected that the TP sensor rotational angle changed beyond the minimum or maximum calibrated limit Scan Tool Tips Monitor the TP V PID, and tap lightly on the TP sensor housing and wiggle the wiring harness Watch for the value to suddenly go below 0.49v or over 4.65v |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | TP Sensor 1 Circuit Conditions |
| Cause | DTC P0606, P1517 and P1518 not set, key in crank or run mode, system voltage over 5.23v, Electronic Throttle Control serial data operational, then the PCM detected that 2 or more APP sensors were out of range, or that all 3 APP sensors disagree, or 1 APP sensor was out of range and the other 2 APP sensors disagree |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Throttle position (TP) motor - fail safe mode |
| Cause | Wiring, TP sensor, TP motor, mechanical fault, ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Throttle position (TP) sensor 1 & 2 - signal malfunction |
| Cause | Wiring, TP sensor, mechanical fault, ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Throttle position (TP) motor - fail safe mode |
| Cause | Wiring, TP sensor, TP motor, mechanical fault, ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Throttle actuator control (TAC) motor - circuit malfunction |
| Cause | Wiring, IAC motor, ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Throttle position (TP) sensor - intermittent circuit fault |
| Cause | Wiring, TP sensor, ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Throttle actuator control (TAC) motor - circuit malfunction |
| Cause | Wiring, TAC motor, ECM |
Try also: https://www.obd-codes.com/p1125
