P1635 OBD Trouble Code
6 results found
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | CAN data bus, AC - no signal |
| Cause | AC control module trouble code(s) stored, wiring, matching resistor in ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Tire Axle/Ratio Out of Acceptable Range Conditions |
| Cause | Engine running and the PCM detected that the tire and axle information in the VID Block does not match the vehicle hardware |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | 5-Volt Reference Circuit Low Conditions |
| Cause | Key on, then the PCM detected that the 5-volt reference circuit input was less than 4.0v (the circuit is monitored continuously) |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Sensor supply voltage - circuit 1 malfunction |
| Cause | Wiring short circuit to ground/positive, ground wiring open circuit, ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Sensor supply voltage - circuit A malfunction |
| Cause | Wiring short circuit to ground/positive, ground wiring open circuit, ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | CAN data bus, AC - no signal |
| Cause | AC control module trouble code(s) stored, wiring, matching resistor in ECM |
Try also: https://www.obd-codes.com/p1635
