P1518 OBD Trouble Code
6 results found
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Engine control relay - short to positive |
| Cause | Wiring short to positive, engine control relay |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Intake Manifold Runner Control Conditions |
| Cause | Key on or engine running, then the PCM detected that the IMRC Monitor signal was less than its expected calibrated range at closed throttle - valve stuck open? |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Throttle Actuator Control Module Performance |
| Cause | Key in the crank or run mode, system voltage over 5.23v, then the ETC or TAC module detected invalid or missing serial data for a specified amount of time, condition met for less than 1 second. |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Intake manifold air control - stuck open |
| Cause | Wiring, air control solenoid, ECM |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Starter motor switch - circuit malfunction |
| Cause | Wiring |
| Type | Powertrain - Manufacturer Controlled DTC - Manufacturer Controlled |
|---|---|
| Description | Engine control relay - short to positive |
| Cause | Wiring short to positive, engine control relay |
Try also: https://www.obd-codes.com/p1518
